Note 0031 min read

A quiet note on rind

Both benches use rind, a crypto library written in Rust. A short note on where it runs now and where it is going.

rind is a cryptography library written in Rust. I do some side work around it. Most of it is not ready to write up, so this note is short.

#Where it already runs

The radio bench from the last note seals every video frame with rind. It runs on a 2015 Raspberry Pi 2, with no assembly and no C toolchain in the build. The cost does not show up in the results.

A recent change gave each run its own key, derived through rind. It was a small diff. It changed what goes on the air, and it changed what a receiver should trust before it has seen a whole group.

#Where it is going

Next are the small boards. The relays on the XIAO bench are ESP32-S3 chips. The USB radio stick is an RP2040. Both are on the list in rind-hardware, which builds rind’s own benchmarks as firmware for chips that size. The results live in rind-results.

Some of that work is written as small patches meant for upstream. A few recent changes affect what is practical on these boards. I will share those with the numbers, not describe them here.

Nothing moves onto a bench board until it is measured there. A board that misses its memory floor does not get the change, however good it looks on a laptop.

More later.

Uses the rind crypto library. This is independent hobby work, not affiliated with or endorsed by rind.